[新品] 高品质不锈钢滤油机(80型)

1、利用真空进油，装置了管状旋转喷油器，减少了阻力，加快了旋转速度，增加了油气分离效果。
2、增加了变质油再生净化功能，增加了硅胶净油系统，并将硅胶净油与杂质过滤合为一体，对于轻度变质的变压器油滤掉杂质后，经过硅胶净油器的吸附再生，使其达到合格油标准。
3、滤油器部分的过滤方法有两种：一种是传统的滤油方法——滤纸做为过滤介质；另一种方法是不需要滤纸的特制精滤滤芯为滤油介质。
4、一机多能。现场使用时，利用原有的带油设备做储油罐，使热油在设备之间循环，这样便使滤油、再生、热油循环干燥三种功能同时进行。省工、省时、确为一举三得。

1, the use of vacuum suction, the tubular rotary injector, reduce the resistance and speed up the rotation speed, increase the separation efficiency of oil and gas.

2, strengthen the function of metamorphic oil regeneration purification, increased net silicone oil system, and the net silicone oil and impurities filtration one, for mild metamorphism of transformer oil filter out impurities, adsorption regeneration after silicone oil purifier, oil to the qualified standard.

Part 3, oil filter, filtering method has two kinds: one kind is the traditional oil filter method, filter paper as filter medium; Another way is to don't need special fine filtration of the filter paper filter for oil filter medium.

4, one can. Field use, using the original belt oil equipment for oil tank, the hot oil circulation between equipment, thus make the oil filter, regeneration, hot oil circulation drying three functions simultaneously. The province, to save time, is really works.

注意事项：Matters needing attention

1、接通电源，必须要接好地线才能操作。

2、操作前，注意电机转动方向，要符合箭头方向。

3、没有油循环时，不得打开加热器，否则会烧坏加热器，重则会炸。

4、排油前，必须打开出油管所有阀门。

5、工作环境温度低于—30℃，高于+40℃，不宜使用。

1, connected to the power supply, must be good earthed to operation.

2, before the operation, pay attention to the motor rotation direction, to conform to the direction of arrow.

3, there is no oil circulation, can not open the heater, otherwise it will burn out heaters, weight will be Fried.

4, before the discharge of oil, must open the flowline all valves.

5, working environment temperature below 30 ℃, higher than + 40 ℃, unfavorable use.